Operation Area - Sega Let’s Go ISLAND! Owner's Manual

2-2 OPERATION AREA

● For the operation of this machine, secure a minimum area of 2.62 m (103.1 in)
width x 2.3 m (90.6 in) depth.
● SEGA shall not be held responsible for damage or compensation for damage to
a third party, resulting from the failure to observe this instruction.
● The ceiling where this product is installed must be at least 2.3 m (90.6 in) high. If the
ceiling is too low, the heat emitted from the product may cause it to catch on fire.
● Be sure to provide sufficient space specified in this manual. Do not allow objects
to block the ventilation ports. It can cause generation of heat and a fire.
● Put the cabinets close together so that people cannot get through or provide
enough space between them that people can go both ways without difficulty.
If the cabinets are installed carelessly, people may bump into each other or
the cabinets when passing between them or fall down. To prevent people from
walking between them, place them 0.15 m (5.9 in) apart.
● If the machine does not fit through the entryway to the installation location,
do not disassemble it without first consulting the instructions. Specific tools
and adjustment procedures are required to assemble and disassemble the
mechanical parts. Attempting to assemble or disassemble the machine without
consulting the instructions may result in accidents during assembly/disassembly
and electric shock, short circuits, and/or personal injury during operation. If the
machine still does not fit through the entryway after following the procedures in
this manual, contact your retailer or the office listed in this manual.
● If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting to
transport the machine while it is tipped on its side may cause accidents. It may also
damage or warp parts of the machine, resulting in accidents during operation.
● To install this product, the entrance must be at least 0.9 m (35.4 in) in width and
1.9 m (74.8 in) in height. If the entrance is too narrow, do not tilt the product
carelessly. If all the product weight is put on the casters at one side only, there
could be damage or deformation, causing serious accidents such as workers
getting caught underneath.
0.7 m (27.6 in)
2.62 m (103.1 in)
PRECAUTIONS REGARDING INSTALLATION LOCATION
7
2