Sony MVS-6520 User Manual page 70

Displaying the transition rates in a menu
and changing the settings
For each of the banks, you can display the transition rate,
independent key transition rate and fade-to-black
transition rate, and change the settings
Pattern Limits
When a wipe or DME wipe pattern is selected for the
transition, you can specify the range of movement of the
wipe pattern through the course of the transition, for each
bank.
When the pattern limit function is enabled, carrying out a
transition results in the following effect for example
settings.
• When the limit value is set to 50%, the effect at the end
of the transition is the same as when the fader lever is at
the center position in the normal case (with the pattern
limit function disabled); the wipe pattern does not
complete.
• When the limit value is set to 0%, the wipe effect is
completely disabled, and carrying out the transition
produces no change in the image.
• When the limit value is set to the maximum 100%, the
image changes in exactly the same way as when the
pattern limit function is off, but when the transition is
completed, the cross-point selections on the background
A and B buses do not interchange.
There are two ways of setting a pattern limit: either by
operating the fader lever to save the fader position, or by
using the Wipe menu or DME Wipe menu to access the
Edge/Direction menu for each bank.
Notes
• A pattern limit only applies when a wipe or DME wipe
is selected as the transition type.
• A pattern limit cannot be applied to an independent key
transition (1 p. 74).
• In multi program mode, a pattern limit can be used only
when the background transition type is a wipe or DME
wipe. If a key is selected for the next transition, the
pattern limit setting is reflected in the wipe or DME wipe
selected by the background transition type.
70
Executing a Transition
(1 p. 150).
Setting the pattern limit with the fader
lever
For assignment of buttons for pattern limits,
Transition Control Block Button Assignments" (p.
1
2
Setting the pattern limit by a menu
operation
1
2
LIMIT SET button
PTN LIMIT button
TRANS PVW button
Transition control block
Move the fader lever to the position corresponding to
a particular pattern size.
First make sure that the [PTN LIMIT] button is off.
To check the pattern size on the preview monitor, first
press the [TRANS PVW] button, to select the
transition preview mode (1 p.
Press the [LIMIT SET] button.
This sets the current fader lever position as the pattern
limit.
When operating from the M/E-1 bank, for example,
open the following menu.
When wipe is selected, open the M/E-1 >Wipe >Edge/
Direction menu (1154).
When DME wipe is selected, open the M/E-1 >DME
Wipe >Edge/Direction menu (1164).
Press [Pattern Limit], turning it on.
1 "Setting
327).
73).