Sony MVS-6520 User Manual page 69

Notes
Whereas you can enter a value of up to 999 in frame input
mode, a value not smaller than 10 seconds cannot be
entered in timecode input mode.
Frame display mode and timecode display
mode
For the transition rate display in the transition control
block, there are two modes: frame display mode and
timecode display mode. You can select one of these modes
in the Setup menu.
1 "Setting the Transition Rate Display
For details,
Mode" (p.
340).
Notes
The setting is common to all banks of the switcher.
Frame display mode: Values are shown as from 0 to 999
frames. In this display mode, a value entered in
timecode input mode is converted for display as a
number of frames.
Timecode display mode: Values are shown as timecode
values, consisting of seconds and frames. In this
display mode, a value entered in frame input mode is
converted for display as a timecode value. If the value
consists of four or more digits, the last digit is not
shown.
Example: A value of 9 seconds 23 frames appears as
"9.23" and a value of 10 seconds 01 frame appears
as "10.0."
Setting the transition rate in the Flexi Pad
1
In the Flexi Pad, press the [TRANS RATE] button.
The button displays in the memory recall section
change as shown in the following illustration, and the
Flexi Pad switches to the transition rate setting mode.
2
In the region selection buttons, select the switcher
bank.
3
Press the [TRNS SEL] button in the memory recall
section.
The button displays in the memory recall section
change as shown in the following illustration, and you
can select the type of transition for which to set the
rate.
4
Press the [TRNS] button.
You can now set the M/E-1 bank background
transition rate.
5
While viewing the alphanumeric display, enter the
transition rate you want to set with the memory recall
section button.
If required, press the [TC] button to toggle the input
mode (frame input or timecode input).
• Enter a value of up to three digits.
• To cancel the input, press any of the mode selection
buttons.
6
Press the [ENTR] button.
Setting the transition rate by a menu
operation
1
When operating from the M/E-1 bank, for example,
open the M/E-1 >Misc >Transition menu (1171).
2
Select any transition type in the <Transition Type>
group.
3
Set the transition rate.
No. Parameter
1 Transition Rate Transition rate
Adjustment
Executing a Transition
69