Sony MVS-6520 User Manual page 279

3
Select a register.
4
Press [Edit].
The Edit menu (6411.1) appears.
You can also use the [Shotbox Reg] parameter to
select the register in this menu.
In the status area, the shotbox register status for each
region appears.
5
Select a region.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
6
In the <Assign> group, select the snapshot or effect to
be allocated to the region.
Snapshot: Allocate a snapshot.
Effect: Allocate a keyframe effect.
If the selected register is locked, a confirmation
message appears asking whether or not to cancel the
operation. Press [OK] to return to the previous menu
display without carrying out the registration.
If the operation is carried out, the region selected in
step 5 is registered in the shotbox, and the parameters
are now valid.
7
Depending on the selection in step 6, set the following
parameters.
When a snapshot is selected
No. Parameter Adjustment
3 Snapshot Snapshot register number
When an effect is selected
No. Parameter Adjustment
3 Effect Keyframe effect register number
8
To run the allocated effect as soon as it is recalled,
press [Auto Run], turning it on.
9
Repeat steps 5 to 8 as required.
10
In the <Store> group, press [Store] to save the setting.
To return to the state before saving the setting
In the <Store> group, press [Undo].
To execute the settings to check them
Press [Recall] to execute the shotbox.
Shotbox Execution
You can recall (and run) shotbox registers from the
following control blocks.
This section describes the various methods of operation.
• Flexi Pad
(1 p. 279)
• Cross-point control block
Executing a Shotbox in the Flexi Pad
1
In the Flexi Pad, press the [SHOTBOX] button,
turning it on.
This switches the memory recall section to shotbox
operation mode.
The alphanumeric display shows the number of the
last recalled register.
2
Using any of the following methods, select the bank.
To select bank 0: Press the [BANK0] button.
To select bank 1: Press the [BANK1] button.
To select any of banks 0 to 9: Press the [BANK SEL]
button, then press the desired bank button (any of
[0] to [9]).
For details about the correspondence between banks
1 "Banks and Registers" (p.
and registers,
This selects the bank, and the buttons in the memory
Lit orange: Register containing shotbox settings
Off: Register in which nothing is saved
3
Press the button in the memory recall section
corresponding to the register you want to run.
The selected button lights yellow, and the shotbox
register is run.
The alphanumeric display shows the selected register
number.
If the selected shotbox register has auto run set, on
recall the effect is immediately executed.
When auto run is not set for the recalled register
Simply recalling the register does not run the effect. To
do this, press the [RUN] button.
(1 p. 280)
268).
Shotbox Execution
279