Sketch Settings - Sony MVS-6520 User Manual

Sketch Settings

Applying the Sketch effect
1
Open the DME >Enhanced Video Modify >Sketch
menu (4171).
2
Press [Sketch], turning it on.
3
Select the method for applying outlines in the <Sketch
Mode> group.
Sketch: Apply an effect like a sketch.
Edge Color: Enhance the outlines.
Draw: Apply an effect like a line drawing.
Relief: Apply a bas-relief effect.
Sharp: Increase the apparent sharpness.
4
Depending on the selection in step 3, set the following
parameters.
When Sketch is selected
No. Parameter Adjustment
1 Mix Mix amount for Sketch video and
input video
2 Clip Reference level for outline
extraction
3 Gain Image gain for outline extraction
4 C Gain Chroma gain of input video
When Edge Color is selected
No. Parameter Adjustment
1 Mix Mix amount for Edge Color video
and input video
2 Clip
Reference level for outline
extraction
When Draw is selected
No. Parameter Adjustment
1 Mix Mix amount for Draw video and
input video
2 Clip Reference level for outline
extraction
3 Gain Image gain for outline extraction
When Relief is selected
No. Parameter Adjustment
1 Mix Mix amount for Relief video and
input video
2 Offset Relief luminance level
3 Gain Image gain for outline extraction
4 Angle
Direction of relief image light
source
When Sharp is selected
No. Parameter Adjustment
1 H Simultaneously adjust the left
and right resolution
2 V Simultaneously adjust the top
and bottom resolution
3 All Simultaneously adjust the
resolution of all four sides
5 Coring Minimum value of edge to
emphasize
5
If you made a selection other than [Sharp] in step 3,
proceed as follows if required.
To adjust the outline color for Edge Color or Draw
Turn [Edge Matte] on and set the following parameters
to set the outline color.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To set the color of the sections other than the
outlines for Draw
Press [Matte], turning it on, and adjust the following
parameters to set the color of the sections other than
the outlines.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
To select the signal to mix with the pattern for
Relief
In the <Chroma Type> group, select the signal to mix
with the relief pattern.
Matte: Select a single color. The following
parameters can be adjusted.
No. Parameter Adjustment
2 Saturation Saturation
3 Hue Hue
Video: Select the input video signal.
6
To invert white and black in the extracted video, or to
invert the outlines and the sections other than the
outlines, press [Nega], turning it on.
To mask the Sketch effect with a selected pattern
Press [Mask] to display the Mask menu (4127)
(1 p. 189), and set the pattern type and modifiers.
Applying Special Effects (Overall Signal Effects)
187