Editing The Wipe Pattern - Sony MVS-6520 User Manual

Editing the Wipe Pattern

By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode, you can edit the
selected wipe pattern.
To exit from the editing mode, press the [EDIT ENBL]
button again, or press the [EXIT] button.
Wipe pattern edge setting buttons
BDR (border): Applies a border to the wipe pattern.
SOFT BDR (soft border): Softens the applied border.
SOFT (soft edge): Softens the edge.
EDGE MAT (edge matte): Selects whether to fill the
edge with a color matte, or insert an image from the
utility bus. By default a color matte is selected.
You can adjust the parameters selected with these buttons
using the adjustment knobs, when the button is lit green.
When border is selected
No. Parameter Adjustment
1 W Border width
2 L Luminance
3 S Saturation
4 H Hue
When soft border is selected
Parameter group [1/2]
No. Parameter Adjustment
1 W Border width
2 I Border inner softness
3 O Border outer softness
Parameter group [2/2]
No. Parameter Adjustment
1 L Luminance
2 S Saturation
3 H Hue
When soft edge is selected
No. Parameter Adjustment
1 S Edge softness
When edge matte is selected
No. Parameter Adjustment
1 L Luminance
2 S Saturation
3 H Hue
Buttons for positioning the wipe pattern
POS (positioner): Adjusts the position of the wipe
pattern.
CNTR (center): Returns the wipe pattern position to the
center.
When you press the [POS] button, the alphanumeric
display first shows the name of the parameter, "H" or "V,"
and then the value of the parameter.
When the [POS] button is lit green, you can adjust the
position of the wipe pattern with the adjustment knobs.
No. Parameter Adjustment
1 H Horizontal position
2 V Vertical position
Buttons for setting the wipe direction
NORM (normal): Sets wipe to normal (forward)
direction.
NORM/REV (normal/reverse): Sets the wipe direction
to alternate between normal and reverse for each
transition.
REV (reverse): Sets wipe to the opposite direction of
normal.
Buttons for setting the wipe pattern limit
PTN LIMT (pattern limit): Enables setting of the pattern
limit using the adjustment knobs.
LIMT SET (limit set): If you change the pattern size with
the fader lever then press this button, this sets the
current size as the pattern limit.
No. Parameter Adjustment
1 P Pattern limit range
Other buttons
EXIT: Exits the editing mode, and returns the memory
recall section to wipe snapshot mode.
KNOB 1/2: When the knob adjustments are on two pages,
this switches between parameter group [1/2] and
parameter group [2/2].
Wipe Pattern Operations in the Flexi Pad
109