Sony MVS-6520 User Manual page 102

Border
Soft
Soft Border
When a border or soft border is selected, the signal filling
the border is called edge fill. For the edge fill, you can use
a matte generated by the dedicated color matte generator,
or the signal selected on the utility bus. A matte can
include color 1 and color 2, and a combination of the two
colors (a "color mix").
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
Select the edge type in the <Edge> group.
3
Depending on the selection in step 2, set the following
parameters.
When Border is selected
No. Parameter
1 Width
When Soft (edge) is selected
No. Parameter
1 Soft
When Soft Border is selected
No. Parameter
1 Width
2 Inner Soft
3 Outer Soft
102
Basic Wipe Setting Operations
Applies a border to the pattern.
Softens the pattern edges.
Softens the border applied to the
pattern.
Adjustment
Border width
Adjustment
Edge softness
Adjustment
Border width
Border inner softness
Border outer softness
4
When you selected Border or Soft Border, select the
edge fill signal in the <Edge Fill> group.
Utility 1 Bus: Signal selected on the utility bus
Matte: Signal from the dedicated color matte
generator
5
Depending on the selection in step 4, carry out the
following operation.
When [Utility 1 Bus] is selected: Hold down the
[UTIL1] button in the 1st row of the cross-point
control block, and select the signal in the 2nd row.
When [Matte] is selected: In the Edge/Direction
menu, press [Matte Adjust] to display the Matte
Adjust menu (1154.1), then adjust the single-color
or two-color combination color matte. Select
whether to use a single-color matte or a two-color
combination in the <Edge Matte> group.
Flat Color: Adjust color 1 with the following
parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
Carrying out a color mix for the edge fill
matte
If you selected [Matte] for the border or soft border edge
fill, you can combine color 1 and color 2.
For the combination, you can use not only a normal wipe
generator pattern, but also the dedicated color mix pattern.
1
In the <Edge Fill> group of the Edge/Direction menu,
select [Matte], and press [Matte Adjust].
The Matte Adjust menu (1154.1) appears.
2
In the <Edge Matte> group, press [Mix Color], turning
it on.
3
In the <Mix Pattern> group, make one of the following
selections.
Wipe: Use the wipe pattern selected for the transition.
Pattern: Use the dedicated pattern.
4
Depending on the selection in step 3, set the following
parameters.
When Wipe is selected
No. Parameter Adjustment
1 Size Pattern size
2 Soft Edge softness