Controls System Maintenance; Adjusting The Clutch Pedal - Toro Workman HDX-D Operator's Manual

Controls System
Maintenance

Adjusting the Clutch Pedal

Service Interval: Every 200 hours
Note:
You can adjust the clutch-pedal cable at the
bell housing or at the clutch-pedal pivot. You can
remove the front hood to easily access to the pedal
pivot.
1. Loosen the jam nuts securing the clutch cable to
the bracket on the bell housing
Note:
You may remove and rotate the ball joint,
if additional adjustment is required.
Figure 61
1. Return spring
2. Ball joint
2. Disconnect the return spring from the clutch
lever.
3. Adjust the jam nuts or ball joint until the rear
edge of the clutch pedal is 9.2 to 9.8 cm (3-5/8
to 3-7/8 inches) from the top of the floor plate
diamond pattern, when you apply 1.8 kg (4 lb) of
force to the pedal
(Figure 61).
3. Jam nuts
4. Clutch cable
(Figure 62).
1. Clutch pedal
Note:
Force is applied so that the clutch-release
bearing lightly contacts the pressure-plate
fingers.
4. Tighten the jam nuts after you attain the proper
adjustment.
5. Check the 9.2 to 9.8 cm (3-5/8 to 3-7/8 inches)
dimension after the jam nuts have been
tightened to ensure proper adjustment.
Note:
Adjust again, if necessary.
6. Connect the return spring to the clutch lever.
Important:
positioned squarely on the ball, not twisted,
and remains parallel to the clutch pedal after
g248360
the jam nut is tightened
Note:
The clutch free play should never be less
than 19 mm (3/4 inch).
1. Clutch-cable rod end
2. Clutch pedal
56
Figure 62
2. 9.2 to 9.8 cm (3-5/8 to
3-7/8 inches)
Ensure that the rod end is
(Figure 63).
Figure 63
3. Rod end jam nut
4. Parallel
g009276
g009277