Maintaining The Transmission - Toro Workman 07390H Operator's Manual

Hdx-auto utility vehicl
Hide thumbs Also See for Workman 07390H:
Table of Contents

Advertisement

A.
Loosen the jam nut at the center of the tie
rod
(Figure
56).
Figure 56
1. Tie rods
B.
Rotate the tie rod to move the front of the
tire inward or outward to achieve the center
to center distances from front to back.
C.
Tighten the tie rod jam nut when the
adjustment is correct.
D.
Check to ensure that the tires turn an equal
amount to the right and to the left.
Note:
If the tires do not turn equally, refer
to the Service Manual for the adjustment
procedure.
g010329
2. Jam nuts
Maintaining the
Transmission
Checking the Transmission-Fluid
Level
Service Interval: After the first 50 hours
Every 400 hours
Transmission-fluid type: Dexron VI
1.
Locate the fill plug at the at the lower-inboard
area at the back of the transmission
1. Fill port (transmission)
2.
Align a drain pan below the fill plug.
3.
Rotate the plug counterclockwise and remove
the plug from the fill port in the transmission
(Figure
57).
Note:
When the transmission fluid level is
correct, the fluid should be level with the bottom
of the threads in the fill port.
4.
If the transmission-fluid level is low, add
transmission fluid of the specified type into the
transmission through the fill port until the fluid
level is flush with the bottom of the threads in
the port
(Figure
Note:
Use a funnel with a flexible hose when
filling the transmission.
5.
Check the condition of the O-ring at the fill plug.
Note:
Replace the O-ring if it is warn or
damaged.
6.
Install the fill plug into the transmission and
tighten it by hand
47
(Figure
Figure 57
2. Fill plug
57).
(Figure
57).
57).
g025534

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman 07390Workman 07390tc

Table of Contents