Lubrication; Greasing The Bearings And Bushings - Toro Workman 07369 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate
more frequently in heavy-duty
applications).
Grease Type: No. 2 lithium grease
1. Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2. With a grease gun, apply grease into the grease
fittings on the machine.
3. Wipe any excess grease off the machine.
Important:
When greasing the drive shaft
universal shaft bearing crosses, pump grease
until it comes out of all 4 cups at each cross.
The grease fitting locations and quantities are as
follows:
•
Ball joints (4); refer to
•
Tie rods (2); refer to
•
Pivot mounts (2); refer to
•
Steering cylinder (2); refer to
Figure 27
•
Spring tower (2); refer to
Figure 27
Figure 27
Figure 27
Figure 27
Figure 28
•
Clutch (1); refer to
•
Accelerator (1); refer to
•
Brake (1); refer to
•
U-joint (18); refer to
•
4-wheel drive shaft (3); refer to
g010360
36
Figure 28
Figure 29
Figure 29
Figure 29
Figure 29
Figure 30
Figure 30
g010571
g002394