Table of Contents
Advertisement
Chapter 3 - Setup and Installation
6
7
8
72
Stand-Alone Dual Port Dual Host Dual Connection Configuration
Connect the Fibre Channel data cable(s).
a
Connect a cable from the first host (Node A) first HBA FC port to the
"H1" connector on the right Host I/O card.
b
Connect another cable from a first host (Node A) second HBA FC port to
the "H1" connector on the left Host I/O card.
c
Connect a cable from the second host (Node B) first HBA FC port to the
"H0" connector on the right Host I/O card.
d
Connect another cable from a second host (Node B) second HBA FC
port to the "H0" connector on the left Host I/O card.
Host Computer Node B
Power
Power
Supply
Supply
imageRAID IRF-1Sxx-xx/IRF-1Dxx-xx
Stand-Alone Dual Port Dual Host Dual Connection Cabling Diagram
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
Loosen the two captive fastener screws on the Disk I/O card and pull it from
the daisy-chain enclosure using the fastener screws. Locate the jumper JP4
and position it for the desired speed setting, (installed on one pin only for 2
Gb mode and on both pins for 1 Gb mode).
FC HBA 2
FC HBA 1
FC HBA 2
Connect to H1
DISK I/O
P1
P2
Cooling
DISK I/O
Fans
P1
P2
SES
RS-232
FC HBA 1
Host Computer Node A
Connect to H1
H0
H0
H1
H1
RAID Controller
Advertisement
Table of Contents
