Fujitsu IRF-1S series User Manual page 105

6 Connect the Fibre Channel data cable(s).
a Connect a cable from the first host (Node A) first HBA FC port to the
"H0" connector on the right Host I/O card.
b
Connect another cable from the first host (Node A) second HBA FC port
to the "H0" connector on the left Host I/O card.
c
Connect another cable from the second host (Node B) first HBA FC port
to the "H1" connector on the left Host I/O card.
d Connect another cable from the second host (Node B) second HBA FC
port to the "H1" connector on the left Host I/O card.
Host Computer Node A
Power Power
Supply Supply
imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx
Multi-Port Mirrored Dual Host-Quad Connection Cabling Diagram
7
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
8 Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
Loosen the two captive fastener screws on the Disk I/O card and pull it from
the daisy-chain enclosure using the fastener screws. Locate the jumper JP4
and position it for the desired speed setting, (installed on one pin only for 2
Gb mode and on both pins for 1 Gb mode).
FC HBA FC HBA FC HBA
Connect to H1
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Multi-Port Mirrored Dual Host-Quad Connection Configuration
Chapter 3 - Setup and Installation
FC HBA
Host Computer Node B
Connect to H1
H0
H0 H1 H1
RAID Controller
RAID Controller
93