Fujitsu IRF-1S series User Manual page 115

6 Connect the Fibre Channel data cable(s).
a Connect your host(s) to the switch.
b Connect a data cable from a switch port to the "H0" connector on the
right Host I/O card.
c
Connect a data cable from another switch port to the "H1" connector on
the right Host I/O card.
d Connect a data cable from another switch port to the "H0" connector on
the left Host I/O card.
e Connect a data cable from another switch port to the "H1" connector on
the left Host I/O card.
Host Computer Node B
Switch 1
Power Power
Supply Supply
imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx
Multi-Port Mirrored SAN Attach-Dual Switch Connection Cabling Diagram
7 If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
FC HBA FC HBA
Connect H0
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Multi-Port Mirrored SAN Attach-Dual Switch Configuration
Chapter 3 - Setup and Installation
FC HBA FC HBA
Host Computer Node A
Switch 2
Connect H1
H0 H1 H0 H1
RAID Controller
RAID Controller
103