Fujitsu IRF-1S series User Manual page 112

Chapter 3 - Setup and Installation
12 Repeat steps 8 through 11 for each additional daisy-chained enclosure.
13 Power on your system, refer to "Powering On the Storage System" on
This completes the setup and cabling of this configuration.
100
Multi-Port Mirrored SAN Attach-Single Switch Configuration
b Connect another data cable from the "P2" connector on the lower Disk
I/O card installed in the primary RAID enclosure to the "P1" connector
on the upper Disk I/O card in the daisy-chain enclosure.
Host Computer Node B
Switch/Hub
Connect H0
Power Power
Supply Supply
imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx
Accesses Loop 0
Drive Slots 1-12
Power Power
Supply Supply
imageRAID IRF-JBOD
Multi-Port Mirrored SAN Attach-Single Switch Connection Cabling Diagram (Daisy-Chain)
CAUTION: When using dual loop topologies, you will be required to install
and use volume management software.
page 107.
FC HBA
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Connect to P1
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
FC HBA
Host Computer Node A
Connect H1
H0
H0 H1 H1
RAID Controller
RAID Controller
Accesses Loop 1
Drive Slots 1-12
Connect to P1