Table of Contents
Advertisement
Chapter 6 - Maintenance
5
6
7
8
9
10 Set the jumpers to match those on the faulty card being replaced.
11 Insert the replacement card by aligning it into the rail guides and push the
12 Insert the transceiver(s) into each of the SFP cages located on the Disk I/O
142
Replacing the Disk I/O Card
Insert the dust covers on the transceiver when they have been removed. This
will protect the optics.
Using a flat-blade screwdriver, loosen the two captive fastener screws that
secure the card.
Using the captive fastener screws, gently pull the card from the enclosure.
Note the position of the jumpers on the faulty card.
Remove the new replacement card from the shipping container and inspect
for obvious damage. Save the packaging materials.
card until it fully seats.
Tighten the two captive fastener screws. Do not overtighten the screws.
card.
Removing the Disk I/O Card
Advertisement
Table of Contents
