Table of Contents
Advertisement
Disk I/O Card Jumper Settings for the IRF-JBOD Enclosures
JUMPER
JP1
JP2
JP3
JP4
* indicates default setting
9
Re-install the Disk I/O card. Repeat step 8 for the second Disk I/O card.
10 Set the SES Controller Card switches in the daisy-chain enclosure. Refer to the
illustration below. See "SES Controller Card Switch Setting Overview" on
page 52 for additional enclosure settings.
Switch Settings
S
A
A
A
S
B
D
R
D
D
D
P
P
D
L
M
0
1
2
0
1
R
Y
T
1 2 3 4 5 6 7 8
SES Controller Card Switch Settings (Daisy Chain Enclosure)
11 Cable the daisy-chain enclosure to the primary RAID enclosure.
a
Connect a data cable from the "P2" connector on the upper Disk I/O
card installed in the primary RAID enclosure to the "P1" connector on the
upper Disk I/O card installed in the daisy-chain enclosure. Refer to the
cabling illustration on the following page.
b
Connect another data cable from the "P2" connector on the lower Disk
I/O card installed in the primary RAID enclosure to the "P1" connector
on the upper Disk I/O card in the daisy-chain enclosure.
INSTALLED BOTH PINS
imageRAID Controllers Only
imageRAID Controllers Only
Split Bus Mode
JBOD Enclosures Only
1 Gb/sec Bus Speed Mode
Slot 1
Slot 4
ID 16
Slot 2
Slot 5
ID 17
UP (1)
Slot 3
Slot 6
DOWN (0)
ID 24
Multi-Port Mirrored Dual Host-Single Connection Configuration
Chapter 3 - Setup and Installation
INSTALLED ONE PIN (OFFSET)
* Non-imageRAID Controllers
* Non-imageRAID Controllers
* Single Bus Mode
RAID Enclosures and Daisy
Chain JBOD Enclosures
* 2 Gb/sec Bus Speed Mode
IDs Assigned to Disk Slots
Slot 7
Slot 10
ID 20
ID 18
ID 22
Slot 8
Slot 11
ID 19
ID 23
ID 21
Slot 9
Slot 12
ID 25
ID 27
ID 26
89
Advertisement
Table of Contents
