Fujitsu IRF-1S series User Manual page 66

Chapter 3 - Setup and Installation
3
This concludes the overview of setting the SES Controller card switches. Locate
your selected operating mode and complete the setup. You will be instructed at
the appropriate time to set the switches as described previously.
"Simplex Mode (imageRAID IRF-1Sxx-xx/IRF-1Dxx-xx)" on page 55.
"Duplex Mode (imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx)" on page 75
54
SES Controller Card Switch Setting Overview
(If necessary) Set the spin-up options for the disk drives. Normally the
default settings are sufficient and configure the spin-up options to spin the
drives up upon a power on condition. However, you may require a specific
or different configurations for the drive spin-up option. Refer to the table
below for the appropriate settings for spin-up options.
"DL" Switch 7
Down *
Down
Up
Up
* Default setting for proper operation.
"Stand-Alone Dual Port Single Host Configuration" on page 55.
"Stand-Alone Dual Port Single Host Dual Connection Configuration" on page 60.
"Stand-Alone Dual Port Dual Host Single Connection Configuration" on page 65
"Stand-Alone Dual Port Dual Host Dual Connection Configuration" on page 70.
"Multi-Port Mirrored Single Host-Single Connection Configuration" on page 75.
"Multi-Port Mirrored Single Host-Dual Connection Configuration" on page 81.
"Multi-Port Mirrored Dual Host-Single Connection Configuration" on page 86.
"Multi-Port Mirrored Dual Host-Quad Connection Configuration" on page 91.
"Multi-Port Mirrored SAN Attach-Single Switch Configuration" on page 96.
"Multi-Port Mirrored SAN Attach-Dual Switch Configuration" on page 101.
"RM" Switch 8
Down * Drive motor spins up at DC power on.
Up Drive motor spins up only on device "start"
commands.
Down Drive motor spins up after a delay of 12
(may vary depending on drive type) seconds
times the numeric device ID setting of the
associated drive.
Up Drive motor will not spin-up.
Drive Spin-up Mode