Powering On The Storage System - Fujitsu IRF-1S series User Manual

Powering On the Storage System

After you have the system setup and installed, you are ready to power on the
storage system enclosure(s).
NOTE: Ensure that the data cables, power cables, or other objects are not
obstructing the air flow exiting the cooling fan module.
1 Locate the power supply On/Off switches at the rear of the enclosure(s).
2 Press each power supply switch to its "On" position. (Repeat this step for
each of the attached storage system enclosure(s).)
All enclosures will perform a power on self test during their initial start.
3
Next power on the host computer(s) which are connected to the storage
system.
Powering Off the Storage System
NOTE: If you are planning to completely shut down the entire system, power
down the host system first.
1 If applicable, ensure that the controller(s) have been gracefully shut down.
2 Press each enclosure's power supply On/Off switches to their "Off" position.
3 Repeat the above step for each of the attached storage system enclosure(s).
Chapter 3 - Setup and Installation
Powering On the Storage System
107