Table of Contents
Advertisement
Chapter 3 - Setup and Installation
7
8
9
10 Set the SES Controller Card switches in the daisy-chain enclosure. Refer to the
58
Stand-Alone Dual Port Single Host Configuration
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
Loosen the two captive fastener screws on the Disk I/O card and pull it from
the daisy-chain enclosure using the fastener screws. Locate the jumper JP4
and position it for the desired speed setting, (installed on one pin only for 2
Gb mode and on both pins for 1 Gb mode).
Disk I/O Card Jumper Settings for the IRF-JBOD Enclosures
JUMPER
JP1
imageRAID Controllers Only
JP2
imageRAID Controllers Only
JP3
Split Bus Mode
JBOD Enclosures Only
JP4
1 Gb/sec Bus Speed Mode
* indicates default setting
Re-install the Disk I/O card. Repeat step 8 for the second Disk I/O card.
illustration below. See "SES Controller Card Switch Setting Overview" on
page 52 for additional enclosure settings.
Switch Settings
S
A
A
A
S
B
D
R
P
D
D
D
P
D
L
M
0
1
2
0
1
R
Y
T
UP (1)
1 2 3 4 5 6 7 8
DOWN (0)
SES Controller Card Switch Settings (Daisy Chain Enclosure)
INSTALLED BOTH PINS
IDs Assigned to Disk Slots
Slot 1
Slot 4
ID 16
ID 18
Slot 2
Slot 5
ID 19
ID 17
Slot 3
Slot 6
ID 25
ID 24
INSTALLED ONE PIN (OFFSET)
* Non-imageRAID Controllers
* Non-imageRAID Controllers
* Single Bus Mode
RAID Enclosures and Daisy
Chain JBOD Enclosures
* 2 Gb/sec Bus Speed Mode
Slot 7
Slot 10
ID 20
ID 22
Slot 8
Slot 11
ID 23
ID 21
Slot 9
Slot 12
ID 27
ID 26
Advertisement
Table of Contents
