Table of Contents
Advertisement
Attaching the Front Bezel (Rack and Tower Models)
2
Remove the dust plugs installed in the SFP cages on both the Disk I/O cards
and the Host I/O cards. Store them for later use.
3
Install the SFP Transceivers.
a
Insert the transceiver(s) into each of the SFP cages on the Disk I/O cards
and Host I/O cards.
The transceiver can only be installed one way. Note the orientation and
ensure you are inserting them correctly.
NOTE:
Refer to the illustration on the following page.
b
Push the transceiver fully into the SFP cage so that it completely seats.
The transceiver protrudes approximately 1/2-inch from the face plate of
the card when it is fully seated.
c
(Optical Transceiver) Remove the dust covers just prior to inserting the
FC data cables and store the dust covers in a safe place.
Chapter 3 - Setup and Installation
Completing the Installation
49
Advertisement
Table of Contents
