Fujitsu IRF-1S series User Manual page 71

11 Cable the daisy-chain enclosure to the primary RAID enclosure.
a Connect a data cable from the "P2" connector on the upper Disk I/O
card installed in the primary RAID enclosure to the "P1" connector on the
upper Disk I/O card installed in the daisy-chain enclosure. Refer to the
cabling illustration below.
b Connect another data cable from the "P2" connector on the upper Disk
I/O card installed in the primary RAID enclosure to the "P1" connector
on the upper Disk I/O card in the daisy-chain enclosure.
Power Power
Supply Supply
imageRAID IRF-1Sxx-xx/IRF-1Dxx-xx
Power Power
Supply Supply
imageRAID IRF-JBOD
Stand-Alone Dual Port Single Host Cabling Diagram (Daisy-Chain Enclosure)
12 Repeat steps 8 through 11 for each additional daisy-chained enclosure.
13 Power on your system, refer to "Powering On the Storage System" on
page 107.
This completes the setup and cabling of this configuration.
Host Computer
H0
DISK I/O
P1 P2
Cooling
DISK I/O
Fans P1 P2
SES
RS-232
Connect to P1
Accesses Loop 0, Drive Slots 1-12
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Stand-Alone Dual Port Single Host Configuration
Chapter 3 - Setup and Installation
FC HBA 1
Connect to H0
H1 H0 H1
RAID Controller
Connect to P1
Accesses Loop 1, Drive Slots 1-12
59