Table of Contents
Advertisement
Chapter 3 - Setup and Installation
6
7
8
62
Stand-Alone Dual Port Single Host Dual Connection Configuration
Connect the Fibre Channel data cable(s).
a
Connect a data cable from the Hub/Switch FC port to the "H0" connector
on the right Host I/O card.
b
Connect another data cable from the Hub/Switch FC port to the "H0"
connector on the left Host I/O card.
Power
Power
Supply
Supply
imageRAID IRF-1Sxx-xx/IRF-1Dxx-xx
Stand-Alone Dual Port Single Host Dual Connection Cabling Diagram
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
Loosen the two captive fastener screws on the Disk I/O card and pull it from
the daisy-chain enclosure using the fastener screws. Locate the jumper JP4
and position it for the desired speed setting, (installed on one pin only for 2
Gb mode and on both pins for 1 Gb mode).
FC HBA 2
Host Computer
Connect to H0
DISK I/O
P1
P2
Cooling
DISK I/O
P1
P2
Fans
SES
RS-232
FC HBA 1
Connect to H0
H0
H1
H0
H1
RAID Controller
Advertisement
Table of Contents
