Dual Link: Two Sce 2000S Topology - Cisco SCE 2000 Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation

Dual Link: Two SCE 2000s Topology

In this topology, two SCE 2000s are connected to two full duplex, GBE links, providing full redundancy
through cascading the two SCE 2000s. The SCE 2000s may be either inline, to support both monitoring
and traffic control functionality, or receive-only for traffic monitoring functionality only.
When installing a cascaded system, it is extremely important to follow the sequence of procedures
Note
outlined in the section
Receive-only topologies can be implemented using either an optical splitter or a switch. If a switch is
Note
used, it must support SPAN functionality that includes separation between ingress and egress traffic and
multiple SPAN-ports destinations.
When two SCE 2000s are used, the first two ports in each SCE 2000 are connected to the links, while
ports 3 and 4 are the cascade ports that are used for communicating between the two SCE 2000s as
follows:
SCE 2000 #1
•
•
•
•
SCE 2000 #2
•
•
•
•
Cascade ports must be connected directly in Layer 1 (dark fibers).
Note
Inline topologies require connecting both Receive and Transmit fibers to the SCE 2000 . Cascade ports
always require both Receive and Transmit fibers to be connected.
The following diagram illustrates the connections for a dual link, two SCE 2000 inline topology.
OL-7824-07
How to Install a Cascaded System, page
Port 1: Link 1, Subscribers side
Port 2: Link 1, Network side
Port 3: Cascade, connect to Port 4 in SCE 2000 #2
Port 4: Cascade, connect to Port 3 in SCE 2000 #2
Port 1: Link 2, Subscribers side
Port 2: Link 2, Network side
Port 3: Cascade, connect to Port 4 in SCE 2000 #1
Port 4: Cascade, connect to Port 3 in SCE 2000 #1
Connecting the Line Ports to the Network
6-10.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-5