How To Install A Service Control Application - Cisco SCE 2000 Installation And Configuration Manual

How to Install a Service Control Application

How to View the Current Link Mode
Step 1 From the SCE> prompt, type show interface linecard 0 link mode and press Enter.
How to View the Current Redundancy Status of the SCE Platform
From the SCE> prompt, type show interface linecard 0 cascade redundancy-status and press Enter.
Step 1
How to View Information about the Peer SCE Platform
Step 1 From the SCE> prompt, type show interface linecard 0 cascade peer-sce-information and press Enter.
How to View Information about the Cascade Connections
Step 1 From the SCE> prompt, type show interface linecard 0 cascade connection-status and press Enter.
How to View the Current Link Mappings
Step 1 From the SCE> prompt, type show interface linecard 0 physically-connected-links and press Enter.
How to Install a Service Control Application
The Service Control solution requires that the Service Control application be installed on the SCE
platform. This is a pqi file that is installed and configured using the Cisco Service Control Application
for Broadband (SCA BB) console.
For an explanation of how to install the pqi file, see
SCE
For information on initial configuration of the application, see
in the
For complete instructions on how to install and configure the SCA BB application, see the
Control Application for Broadband User
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-14
Platform" section in the Cisco Service Control Product Installation
Cisco Service Control Product Installation
Chapter 6 Cabling the Line Ports and Completing the Installation
"Installing the Application and Protocol Pack on the
"Initial SCA BB
Guide.
Guide.
Guide.
Configuration" section
Cisco Service
OL-7824-07