Introduction - Cisco SCE 2000 Installation And Configuration Manual

Cabling the Line Ports and Completing the
Installation
Revised: July 27, 2009, OL-7824-07

Introduction

This chapter provides instructions for cabling the Gigabit Ethernet ports for both one and two SCE 2000
topologies, and for configuring Gigabit Ethernet (GBE) interface parameters. In a topology utilizing two
SCE 2000 s (cascade), this includes the cascade ports as well as the line ports.
When installing a cascaded system, it is extremely important to follow the sequence of procedures
Note
outlined in the section
When installing an External Optical Bypass module, the SCE 2000 line ports are connected to the
Note
module. Refer to
•
•
•
Connecting the Line Ports to the Network
•
•
•
•
•
OL-7824-07
How to Install a Cascaded System, page
How to Cable the External Optical Bypass Module, page A-5
Connecting the Line Ports to the Network, page 6-1
Information About Cascaded Systems, page 6-10
How to Install a Service Control Application, page 6-14
Cabling Diagrams, page 6-2
How to Configure the GBE Interface Parameters, page 6-7
How to Cable the GBE Line Interface Ports, page 6-7
Testing Connectivity: Examining Link LEDs and Counters to Verify that the Network Traffic is
Reaching the Device, page 6-9
What to Do Next, page 6-10
C H A P T E R
6-10.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6
for complete instructions.
6-1