Appendix; Cli Commands To Verify A Successful Installation; Introduction; Basic Post-Installation Checklist - Cisco SCE 2000 Installation And Configuration Manual

CLI Commands to Verify a Successful Installation

Revised: July 27, 2009, OL-7824-07

Introduction

When you have completed the installation of your Cisco SCE 2000 platform, we recommend that you
run a number of CLI commands to verify that the proper components have been successfully installed
and are operational.

Basic Post-Installation Checklist

The following table provides a basic post-installation checklist with the related CLI commands. Further
verification of the system configuration would depend on the specific topology and configuration of the
installation, but this list will verify that the basic installation is operational.
Refer to the descriptions of the individual commands for samples of the command output. Relevant
information in the output is in bold.
To check this: Use this command:
version

show version

port configuration show interface
operational status show system operational status
linecard status show interface linecard
OL-7824-07
A P P E N D I X
Comments
Check the following:
firmware version
•
application version
•
management agent status
•
management agent version
•
optic mode
•
Run this command for each port to get a listing of the status
and configuration of all ports.
Status should be operational.
This command will give you an indication of problems such
as a power problem or external bypass not configured
properly.
It should not be shutdown or silent.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
B
B-1