Cisco SCE 2000 Installation And Configuration Manual page 87

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
You are asked whether to apply and save the configuration.
Step 3
Apply and Save this configuration? [yes/no]:
To apply and save the configuration, type y and press Enter.
•
To abort the setup procedure without applying or saving the configuration (recommended if there
•
are errors), type nand press Enter.
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
If there are no errors, the system requests confirmation of either a yes or no answer, in order to prevent
Step 4
mistakes.
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just entered, are
you sure? [yes/no]:
The selected action is carried out by the system.
• If the apply and save action is not confirmed (no ), the setup is aborted.
Setup procedure aborted, no configuration changes made.
• If the apply and save action is confirmed (yes ), the configuration is applied and saved.
The new running configuration will be saved to the startup configuration.
Step 5 If the configuration was applied and saved, you may also save it to a file at a remote station.
Do you want to save a copy of the startup configuration file in a remote station? [no]:
To save the configuration to a remote station, type y and press Enter.
The system will ask for FTP path:
Enter a full FTP path of the remote destination:
The system informs you that the configuration is complete.
Step 6
Committing configuration...
Configuration completed successfully.
Saving configuration...
Writing general configuration file to temporary location...
Backing-up general configuration file...
Copy temporary file to final location...
Done!
OL-7824-07
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-23