Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
Type the time zone abbreviation and press Enter.
Step 1
Enter time zone name [UTC]: CET
Type the minutes offset from UTC and press Enter.
Step 2
Enter time zone minutes offset from UTC: 60
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
If the time and date are correct, go to .
Step 3
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: y Confirm your response and type the new
time and date.
This change will take effect immediately both on the system clock and calendar;
it will also set the time zone you entered. Are you sure? [yes/no]: y Enter new local time
and date: 14:00:01 1 July 2002Time zone was successfully set.
The system clock and the calendar were successfully set.
You are asked whether you wish to enter the SNTP configuration menu.
Step 4
If you do not wish to configure the SNTP, skip the rest of this section and go to .
To enter the SNTP configuration dialog, type y, and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Step 5
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
To disable the SNTP broadcast client, press Enter.
•
To enable the SNTP broadcast client, type y and press Enter.
•
Enable SNTP broadcast client? [no]:
Define the time interval between unicast updates.
Step 6
•
To accept the displayed default value, press Enter.
•
To change the value, type the desired number of seconds (64 through 1024) and press Enter.
Enter time interval in seconds between unicast updates [1024]:
You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP address in the
Step 7
form x.x.x.x, and press Enter.
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1
OL-7824-07
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-9