Cisco SCE 2000 Installation And Configuration Manual page 81

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Assign an access list to restrict the SNMP management stations that may use this SET community.
Step 7
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow all:
The maximum number of SET communities is 20.
Step 8
To add more entries, type y and press Enter.
•
Would you like to add another SNMP SET community? [no]: y
Enter up to 20 SNMP SET communities as described.
•
When all entries have been added, press Enter.
•
Would you like to add another SNMP SET community? [no]:
Enter the SNMP trap managers menu.
Step 9
Would you like to configure SNMP trap managers? [no]: y
Type y and press Enter.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure trap
status.
Type the trap manager IP address and press Enter.
Step 10
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Step 11 Type the trap manager community string and press Enter.
Note that there is no default for this parameter.
Enter SNMP trap manager community string:
Type the number of the trap manager SNMP version (1 or 2c) and press Enter.
Step 12
Note that there is no default for this parameter.
Enter trap manager SNMP version:
The maximum number of trap managers is 20.
Step 13
To add more entries, type y and press Enter.
•
Would you like to add another SNMP trap manager? [no]: y
Enter up to 20 trap managers as described.
•
When all entries have been added, press Enter.
•
Would you like to add another SNMP trap manager? [no]:
Configure the Authentication Failure trap status.
Step 14
To disable the Authentication Failure trap, press Enter.
•
• To enable the Authentication Failure trap, type y and press Enter.
Enable the 'Authentication Failure' trap [no]:
OL-7824-07
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-17