Table of Contents
Advertisement
Rebooting and Shutting Down the SCE Platform
Rebooting and Shutting Down the SCE Platform
•
•
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new firmware, in order for that firmware to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
When the SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
At the SCE 2000# prompt, type reload and press Enter.
Step 1
A confirmation message appears.
Type y to confirm the reboot request and press Enter.
Step 2
Examples for Rebooting the SCE Platform
The following example shows the commands for system reboot.
SCE 2000# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
How to Shut Down the SCE Platform
Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in
Step 1
Connect to the serial console port (The CON connector on the SCE platform front panel, 9600 baud).
The SCE 2000# prompt appears.
Type reload shutdown.
Step 2
A confirmation message appears.
Type y to confirm the shutdown request and press Enter.
Step 3
Cisco SCE 2000 4xGBE Installation and Configuration Guide
7-10
Rebooting the SCE Platform, page 7-10
How to Shut Down the SCE Platform, page 7-10
How to Save or Change the Configuration Settings, page
How to Save or Change the Configuration Settings, page
Chapter 7
Basic SCE 2000 Platform Operations
7-5.
7-5.
OL-7824-07
Advertisement
Table of Contents
Troubleshooting
