Cisco SCE 2000 Installation And Configuration Manual page 121

Chapter 8 Troubleshooting
SCE 2000 Operational Status
Table 8-2
reflects the current SCE 2000 operational status. The operational status can be displayed using CLI
command show system operation-status.
Table 8-2
SCE 2000
Operational Status Description
Booting
Operational
Warning
Failure
OL-7824-07
lists the operational states of the SCE 2000. The Status LED on the SCE 2000 Front Panel
SCE 2000 Operational States
Initial state after reset
SCE 2000 becomes operational after completing the following
process:
Boot is completed
•
Power self-tests are completed without failure
•
Platform configuration is applied
•
SCE 2000 is fully operational (as above) but one of the following
occurred:
Line ports (GBE ports) to the link are down
•
• Management port link is down
• Temperature raised above threshold
• Voltage not in required range
Fans problem
•
Power supply problem
•
Insufficient space on the disk
•
Warning Note: If the condition that caused the SCE 2000
Note
to be in Warning state is resolved (for example, link is up)
the SCE 2000 reverts to Operational state. Flashing
orange
System is in Failure state after Boot due to one of the following
conditions:
• Power on test failure
• Three abnormal reboots in less than 20 minutes
• Platform configured to enter Failure mode consequent to
failure-induced reboot (this is configurable using CLI
command)
Depending on the cause of failure, the management
Note
interface and the platform configuration may or may not
be active/available. Red
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Troubleshooting Overview
Status LED
State
Orange
Flashing green
Flashing
orange
Red
8-5