Document Revision History; Organization - Cisco SCE 2000 Installation And Configuration Manual

Document Revision History

Table 1 Document Revision History
Cisco Service Control
Revision Release and Date
OL-7824-07 3.5.5
July 27, 2009
OL-7824-06 3.1.0
May, 2007
OL-7824-05 3.0.5
November, 2006
OL-7824-04 3.0.0
February, 2006
OL-7824-03 3.0
December, 2005
OL-7824-02 2.5.7
August, 2005

Organization

The major sections of this guide are as follows:
Table 2
Chapter
1
2
3
4
5
Cisco SCE 2000 4xGBE Installation and Configuration Guide
x
Change Summary
• Added information regarding the new parameter in the connection-mode
command (see Topology-Related Parameters, page
Added Appendix B, "CLI Commands to Verify a Successful Installation"
•
Various minor updates and corrections.
Added requirement for dark fiber cabling between cascade ports.
•
Added maximum hostname length
•
Updated circuit breaker information.
Added the following new feature:
Redundant management (Mng) port
•
Complete reorganization and revision of product documentation.
Document Organization
Title
General Overview, page 1-1
Introduction to the SCE Platform, page 2-1
Information About Topology, page 3-1
Installation and Maintenance, page 4-1
Connecting the Management Interfaces and
Performing Initial System Configuration,
page 5-1
3-11)
Description
This chapter provides a brief introduction to
Cisco Service Control.
This chapter provides a hardware overview
of the SCE 2000 platform.
This chapter describes the possible
deployment topologies of the SCE 2000 and
explains how various aspects of the topology
determine the configuration of the system.
This chapter explains how to install an SCE
2000 platform in a rack or in a general
tabletop installation and how to install or
replace the power supply units and fan
modules.
This chapter explains how to connect the
SCE 2000 platform to a local console and
perform the initial system configuration via
the setup wizard that runs automatically.
About this Guide
OL-7824-07