Cisco SCE 2000 Installation And Configuration Manual page 69

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Table 5-1
Parameter
Access Control List number
list entries (maximum 20 per
list)
IP access ACL
telnet ACL
SNMP Configuration
SNMP agent status
GET community names
SET community names
trap managers (maximum 20)
Authentication Failure trap
status
enterprise traps status
system administrator
Topology Configuration
Connection mode
type of deployment
physically connected link
(cascade topology only)
priority (cascade topology only) If this is a cascaded topology, is this SCE 2000 the primary or
on-failure behavior (inline
connection mode only)
Admin status of the SCE 2000
after abnormal boot
OL-7824-07
Setup Command Parameters (continued)
Definition
How many ACLs will be necessary? What IP addresses will be
permitted/denied access for each management interface? You may
want ACLs for the following:
• Any IP access
Telnet access
•
SNMP GET access
•
SNMP SET access
•
IP address, and whether permitted or denied access.
ID number of the ACL controlling IP access.
ID number of the ACL controlling telnet access.
Enable or disable SNMP management.
Community strings to allow GET access and associated ACLs
(maximum 20).
Community strings to allow SET access and associated ACLs
(maximum 20).
Trap manager IP address, community string, and SNMP version.
Sets the status of the Authentication Failure traps.
Sets the status of the enterprise traps.
Name of the system administrator.
Is the SCE 2000 installed using inline topology or receive-only
topology using an optical splitter?
Is this a cascade topology, with two SCE 2000s connected via the
cascade ports? Or is this a single platform topology?
In a cascade deployment this parameter sets the index for the link
that this SCE 2000 is deployed on. The options for SCE 2000 are
link-0 or link-1.
In a single- SCE 2000 platform deployment, this parameter is not
relevant since one SCE 2000 is deployed on both links. In this case
the link connected to port1-port2 is by default link-0 and the link
connected to port3-port4 is be default link-1.
secondary SCE 2000?
If this SCE 2000 is deployed inline, should the failure behavior be
bypass or cutoff of the link?
After a reboot due to a failure, should the SCE 2000 remain in a
Failure status or move to operational status provided no other
problem was detected?
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-5