Appendix B Converting An Autonomou Acces Point; Obtaining The Ap521 Access Point Conversion Image File - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Obtaining the AP521 Access Point Conversion Image File

Figure B-2
Record the software version of your access point.
Step 3
Note
Obtaining the AP521 Access Point Conversion Image File
The AP521 access point conversion image file is located on Cisco.com. To obtain the conversion image
file on Cisco.com, follow these instructions:
Step 1 Use your Internet browser to access the Cisco Software Center on Cisco.com at the following URL:
http://www.cisco.com/en/US/products/ps7319/index.html
Step 2 Click Download Software in the Support box.
Note
Step 3 Click Yes on the Security Alert pop-up message.
Click IOS Software.
Step 4
On the Log In page, enter your Cisco.com username and password and click Log In.
Step 5
Click Cisco 500 Series Wireless Express Access Points under Cisco Mobility Express.
Step 6
Click Cisco 521 Wireless Express Access Point.
Step 7
Under Latest Releases, click the software version that matches your AP521 access point, such as
Step 8
12.4.3g-JX2(ED) for an access point with 12.4.3g.JX or 12.4.3g.JX2 software.
Click Wireless LAN LWAP RECOVERY.
Step 9
Click DOWNLOAD to obtain the conversion image file.
Step 10
Read and accept the terms and conditions of the Software License Agreement.
Step 11
Click Save to download your image file (such as c529-rcvk9w8-tar.124-3g.JX2.tar) to your hard disk.
Step 12
Select the desired download location on your hard disk and click Save.
Step 13
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
B-2
AP521 Access Point Properties
The access point conversion image must be chosen to match the current software version of your
AP521 access point.
You must register or be a registered user of Cisco.com to download software.
Appendix B Converting an Autonomous Access Point
OL-15283-01