Agilent Technologies MSO6012A User Manual page 71

2 Front-Panel Controls
70
the captured waveform before the trigger (turn the knob
clockwise) or after the trigger (turn the knob counterclockwise).
See "To set up the Horizontal time base"
19. Horizontal Main/Delayed Key
menu where you can split the oscilloscope display into Main
and Delayed sections, and where you can select XY and Roll
modes. You can also select horizontal time/division vernier and
select the trigger time reference point on this menu. See
up the Horizontal time base"
20. Horizontal Sweep Speed Control
sweep speed. This changes the time per horizontal division on
the display. When adjusted after the waveform has been
acquired and the oscilloscope is stopped, this has the effect of
stretching out or squeezing the waveform horizontally. See
set up the Horizontal time base"
21. Measure Keys
Press the Cursors key to switch on cursors
that you can use for making measurements. Press the Quick
Meas key to access a set of predefined measurements. See
Chapter 5, "Making Measurements," starting on page 199.
22. Display
The display shows captured waveforms using a
different color for each channel. For more information about
display modes see Chapter
page 251. Signal detail is displayed using 256 levels of intensity.
For more information about viewing signal detail see
the intensity to view signal detail"
23. Entry Knob
The entry knob is used to select items from
menus and to change values. Its function changes based upon
which menu is displayed. Note that the curved arrow
symbol above the entry knob illuminates whenever the
entry knob can be used to select a value. Use the entry knob to
select among the choices that are shown on the softkeys.
on page 86.
Press this key to access the
on page 86.
Turn this knob to adjust the
on page 86.
6, "Displaying Data," starting on
on page 257.
6000 Series Oscilloscope User's Guide
"To set
"To
"Varying