Agilent Technologies MSO6012A User Manual page 156

6000 Series Oscilloscope User's Guide
Note that the BUSDOCTOR is shipped pre-configured with an IP
address of 192.168.80.<serial number>, and a subnet mask of
255.255.240.0. See the DECOMSYS::BUSDOCTOR 2 user manual
for more information.
4 Set the oscilloscope's IP address:
1 Press Utility & IO & Control. Deselect the LAN check box
(turn it off).
2 Press the LAN Settings softkey.
3 Press the Config softkey. Deselect DHCP and AutoIP.
4 Press the Address softkey. Press the Modify softkey. Set the
oscilloscope's IP address to 192.168.80.1 (the last number
in the IP address must be different from the
BUSDOCTOR's). Press the Apply softkey.
5 Press the Modify softkey twice. Set the oscilloscope's
Subnet mask to 255.255.240.0. Press the Apply softkey.
6 Press the Modify softkey twice. Set the oscilloscope's
Gateway IP to 192.168.80.1. Press the Apply softkey.
Selecting the BUSDOCTOR 2 Control/Operating Mode
1 In the BUSDOCTOR 2 Menu (see
on page 153), press the Mode softkey to select one of
Menu"
these operating modes:
PC — PC with VISION software controls BUSDOCTOR.
•
Asynchronous — oscilloscope controls BUSDOCTOR,
•
asynchronous monitoring mode.
Synchronous — oscilloscope controls BUSDOCTOR,
•
synchronous monitoring mode.
In PC Mode
There is no need to specify additional options or
connect the oscilloscope to the BUSDOCTOR's (ethernet) LAN
control interface. The BUSDOCTOR must be connected to the
PC via LAN.
Triggering the Oscilloscope
"Accessing the BUSDOCTOR
4
155