Agilent Technologies MSO6012A User Manual page 355

9 Characteristics and Specifications
Trigger out
10 MHz ref in/out
Kensington lock
Power requirements
Line Rating
Environmental characteristics
Ambient temperature
Humidity
Altitude
Vibration
Shock
Pollution degree2
Indoor use
Other
Measurement categories
Regulatory information
Supplementary information
354
When "Triggers" is selected (delay ~17 ns; 23 ns for 100 MHz bandwidth models)
0 to 5 V into open circuit
0 to 2.5 V into 50 Ω
When "Source Frequency" or "Source Frequency/8" is selected
0 to 580 mV into open circuit
0 to 290 mV into 50 Ω
Max frequency output:
350 MHz (in Source Frequency mode when terminated in 50 Ω)
125 MHz (in Source Frequency/8 mode when terminated in 50 Ω)
TTL out, 180 mV to 1 V amplitude with 0 to 2 V offset
Connection on rear panel for security
~Line 120 W max, 96-144 V/48-440 Hz, 192-288 V/48-66 Hz, automatic selection
Operating –10 °C to +55 °C; non-operating –51 °C to +71 °C
Operating 95% RH at 40 °C for 24 hr; non-operating 90% RH at 65 °C for 24 hr
Operating to 4,570 m (15,000 ft); non-operating to 15,244 m (50,000 ft)
Agilent class B1 and MIL-PRF-28800F; Class 3 random
Agilent class B1 and MIL-PRF-28800F; (operating 30 g, 1/2 sine, 11-ms duration,
3 shocks/axis along major axis. Total of 18 shocks)
Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation must be expected.
Rated for indoor use only
CAT I: Mains isolated
CAT II: Line voltage in appliance and to wall outlet
Safety IEC 61010-1:2001 / EN 61010-1:2001
Canada: CSA C22.2 No. 61010-1:2004
USA: UL 61010-1:2004
The product herewith complies with the requirements of the Low Voltage Directive
73/23/EEC and the EMC Directive 89/336/EEC, and carries the CE-marking accordingly.
The product was tested in a typical configuration with HP/Agilent test systems.
Product specifications, characteristics, and descriptions in this document are subject to
change without notice.
6000 Series Oscilloscope User's Guide