Table of Contents
Advertisement
4
Registration Overview
You must register the Dual Radio Module with its associated handsets. For single zone operation, each handset
must be registered to its associated radio module; each radio module can be registered with one or two handsets.
For a handset being used in a dual zone configuration, the handset must be registered to a radio module in each of
the two zones.
Setting Up and Registering the Handset
For a detailed description of the handset and its features, see
Pocket
Phone." There, you will find a drawing of the handset with a description of its features, and procedures
for configuring and using your telephone, as well as directions for performing a Local and a Wireless Test of the
handset.
Registering a Handset
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
Registering the Pocket Phone
to a Dual Radio Module
Before you begin using your telephone, you must:
Insert the charged battery pack into the handset.
1
2
Register the handset with the correct radio module(s).
To register your handset with the radio module to which it will be connected in a
single zone configuration or the first zone of a dual configuration:
Signal the radio module that registration is about to start by pressing the Handset
1
Registration activation button on the Dual Radio Module corresponding to the
Line (1 or 2) to which the handset will be registered.
Note:
After you press the Handset Registration activation button on the Dual
Radio Module, there is a 5 minute time limit to complete the registration
process. If no further action is taken during this span of time, the radio
module will time out, and you must start the registration process again.
At the handset, press
2
The initial Menu screen displays.
Chapter
5,
"Programming & Using the MDW 9040
Menu
.
Ä
Options
Configuration
Test Mode
Sel
Exit
35
Issue 2, February 2001
Advertisement
Table of Contents
