Table of Contents
Advertisement
4
Registering the Pocket Phone to a Dual Radio Module
Mapping to the Correct Communications System
The communications system you use determines what information the MDW 9040 Pocket Phone can display and
how the phone lines and programmable/intercom/drop buttons are identified. (For a detailed description of
Button Mapping, see the appropriate "Button Mapping" topics in
Compatibility.")
Reacting to the Button
Mapping Display
Screens
If your handset has been
registered to this type of
Dual Radio Module:
DRM-D
DRM-D
DRM-E
DRM-E
40
Issue 2, February 2001
During the registration process between the handset and the radio module, the handset
notes the type of radio module to which it is connected (either a
DRM-D or a DRM-E). When your handset has been successfully registered, and
when the radio module is connected to the switch, the associated default button
mapping will flash. The table below lists the default switch interfaces for each radio
module type.
The Dual Radio Module is connected to:
DEFINITY
MERLIN MAGIX
MERLIN
PARTNER
MERLIN LEGEND with PARTNER Card
MERLIN MAGIX with PARTNER Card
If your communication system is not the default switch listed in the table above, you
must set the correct Button Mapping. Use the following procedures to verify that your
handset is mapped to the correct communications system.
Press
to enter Menu Mode.
1
Menu
Press the Select-Row (
2
Configuration.
Press the Softkey (
3
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
Chapter
6,
"MDW 9040 Pocket Phone
Ä
Options
Configuration
Test Mode
Sel
Exit
) button until the arrow is to the right of
Options
Ä
Configuration
Test Mode
Sel
Exit
) below Sel.
CONFIGURE MENU
Ä
Registration
Button Map
Sel
More
Back
Mapping to the Correct
The default button
mapping is:
DEFINITY
MERLIN MAGIX
MERLIN
PARTNER
Advertisement
Table of Contents
