Table of Contents
Advertisement
Setting Up and Registering the Handset Registering the Pocket Phone to a Dual Radio Module
Registering the Second Zone of a Dual Zone Configuration
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
The LEDs on the radio module have the following meaning.
Flashing Power LED
Flashing Control LED
IMPORTANT NOTE: The radio module will NOT allow the registration
process to occur if there is anything preventing registration such as the radio
module actively communicating with a previously registered handset.
7
To exit any screen and move back to the previous screen, OR, if you do not want
to make any changes at this time, press the Softkey (
8
Proceed to the instructions in
on
page
40.
To register your handset with the radio modules to which it will be connected in a
dual zone configuration:
Follow the procedures in the previous section,
1
page
35.
2
Select Zone 2 in Step 5 to register the handset with the other radio module with
which it will be associated for dual zone operation.
The following occurs:
The second radio module makes checks regarding the handset registration
•
request.
If there are no unexpected conditions, the associated base module and
•
handset communicate using special link-up signaling.
•
The handset displays a "Registration Completed" message to the user.
The LEDs on the radio module have the following meaning.
Flashing Power LED
Flashing Control LED
IMPORTANT NOTE: The radio module will NOT allow the registration
process to occur if there is anything preventing registration such as the radio
module actively communicating with a previously registered handset.
Handset is in Registration Mode
for Line 1
Handset is in Registration Mode
for Line 2
"Mapping to the Correct Communications
"Registering a
Handset is in Registration Mode
for Line 1
Handset is in Registration Mode
for Line 2
) below Back.
System"
Handset" on
37
Issue 2, February 2001
Advertisement
Table of Contents
