5
Programming & Using the MDW 9040 Pocket Phone
62
Issue 2, February 2001
Press the Softkey (
6
The handset emits a simulated dial tone, which continues until you exit Wireless
Test Mode. The radio module LED signals flash in a unique pattern to identify the
test ports.
The Wireless Test Mode results screen displays. (H = handset reading, B =
base/radio module reading.).
Note:
Press the Softkey (
time the Softkey is pressed below Man, new manual readings will
display. To get an average reading, press this button a number of times
(multiple readings).
Press the Softkey (
every three seconds. The automatic condition continues until either the
manual Softkey button is pressed, or you exit Wireless Test Mode.
To determine signal strength for both the handset and the radio module, press the
7
Softkey (
) below Man or Auto.
The display shows the signal strength (SIGNAL) for both the handset (H) and the
base (B) (the Dual Radio Module) at the moment that the Softkey was pressed,
using a number from 1 to 10.
The higher the number, the stronger the signal, as shown in the following table.
Display Number
10
9
8
7
6
5
4
3
2
1
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
Setting or Changing Handset Settings
) below Sel.
SIGNAL:
H=
B=
VOICE:
H=
B=
POWER:
H=
B=
Man
Auto
Back
) below Man to get manual test readings. Each
) below Auto to get automatic test readings
Signal Strength Is
Strong
Strong
Strong
Very Good
Very Good
Good
Good to Fair
Fair
Near end of range
Near end of range/loss of link