Table of Contents
Advertisement
2
Installing the MDW 9040 Pocket Phone System
Inserting a Battery Pack into the Spare Battery Compartment
Inserting the Battery
Pack
26
Issue 2, February 2001
Plug the battery charger's power cord/AC adapter into a properly grounded,
7
wall outlet that is not controlled by an on/off switch.
Slide the battery pack (or an optional extended battery pack) into the spare battery
compartment until it is firmly seated, that is, with the back of the battery pack against
the back of the spare battery compartment. Do not force the battery pack down. The
battery pack should slide easily into the slot.
Correct positioning of the battery pack in the charger is important to ensure proper
charging. The bottom end of either battery pack also has two small round holes that
must align with two guide pins on the bottom of the spare battery compartment. When
a battery pack is positioned correctly in the spare battery compartment, the SPARE
LED on the front of the battery charger lights.
The spare battery compartment has a vertical ridge on each side that serves as a
"guide rail" for positioning the standard battery pack.
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
The Battery Charger
Advertisement
Table of Contents
