Miele HR1956 Operating Instructions Manual page 134

Problem solving guide
Problem
The oven does not heat
up.
Power cut - process
appears in the
cancelled
display.
12:00 has appeared in
the display.
Maximum operating duration
appears in the
reached
display.

Fault XX appears in
the display
Door not locked appears
in the display.
Door not released
in the display.
No signal to food probe.
Reposition food probe in the
appears in the
oven.
display.
134
Cause and remedy
Demo mode has been activated.
The oven can be operated but does not heat up.
 Deactivate demo mode. See "Settings -
Showroom programme".
There has been a power cut which has caused a
current process to stop.
 Switch the oven off and then back on again.
 Start the programme again.
The power supply was interrupted for longer than 200
hours.
 Reset the time and date.
The oven has been operating for an unusually long
time and this has activated the safety switch-off
function.
 Confirm with OK. Touch  to delete the message
Process finished
The oven is now ready to use.
There is a problem that you cannot resolve.
 Call Miele Service.
The Pyrolytic cleaning programme door lock is not
locking.
 Switch the oven off and then back on again. Then
restart the Pyrolytic cleaning programme.
 If the message appears again, call Miele Service.
appears The door lock for the Pyrolytic cleaning programme is
not being released.
 Switch the oven off and then back on again.
 If the door lock still does not deactivate itself,
contact Miele.
The food probe is no longer recognised by the oven.
 Reposition the food probe in the food.
If the oven still does not recognise the food probe it
must be faulty. A replacement food probe can be
ordered from Miele or from your Miele dealer.
.