Resetting; Front Panel Lock (Executive Mode); Connecting To The Usb Port - Extron electronics DTP T SW4 HD 4K User Manual

Resetting

To reset the switcher to its factory default settings using the front panel buttons:
1.
2.
NOTE: The switcher can also be reset to its factory default settings using SIS

Front Panel Lock (Executive Mode)

Front panel lock mode disables all front panel controls, locking out users from those
functions (RS-232, USB, and IR control remain available). Putting the switcher in executive
mode enhances security by protecting against inappropriate or accidental changes to
settings. If a front panel button is pressed during executive mode, all front panel LEDs blink
once.
To lock or unlock the front panel:
1.
2.
The front panel LEDs blink three times, indicating that executive mode has been enabled or
disabled (see figure 13).
Press and hold simultaneously for 3 seconds.
Figure 13.

Connecting to the USB Port

The mini-B USB port is located on the front panel of the DTP T SW4 HD 4K. Use this port to
configure the switcher via SIS commands or Product Configuration Software (PCS).
1.
Press and hold the
Input
Continue holding the
Input
commands (see Reset on page 45) or PCS (see
Press and hold the
Input 1
Release Input buttons.
1 2
Enabling or Disabling Executive Mode
Connect a USB A to mini-B cable between the USB Config port on the switcher front
panel and the USB port on a computer (see figure 14 below).
Mini Type B
INPUTS
1 2
AUTO
SWITCH
CONFIG
DTP T SW4 HD 4K Front Panel DTP T SW4 HD 4K F t P
Figure 14. USB Port Connection
button while powering-up the unit.
1
button until the power-up sequence completes.
1
Device Menu
button and button simultaneously for 3 seconds.
Input 2
Release buttons. LEDs blink 3 times.
Type A
USB
USB
USB Cable
INPUTS OUTPUT
3 4
SIGNAL
1 2 3 4
HDCP
DTP T SW4 HD 4K
DTP HDMI SWITCHER
l
DTP T SW4 HD 4K • Operation
on page 36).
1 2 3 4
WiFi
USB
Ports
PC
24