Table of Contents
Advertisement
Installation
This section describes the installation and setup of the DTP T SW4 HD 4K switcher. Topics
include:
•
•
•
•
Installation Overview
To install and setup the DTP T SW4 HD 4K switcher:
1.
2.
3.
4.
5.
6.
7.
Installation Overview
Rear Panel Features
Wiring Connections
Securing the HDMI Connector
Turn off all equipment and disconnect from the power source.
Mount the switcher (optional) on a rack shelf or furniture (see
DTP T SW4 HD 4K Switcher
Connect HDMI input sources to one or more of the DTP T SW4 HD 4K inputs. The
default (Extron) EDID is present at each input and Hot Plug Detect (HPD) is actively
controlled on each input.
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
inputs to reduce stress on the connectors and prevent signal loss due to loose
cable connections (see
Connect Contact/Tally input sources (optional) to the ports (see
page 5 and
Contact/Tally Modes
Connect an RJ‑45 DTP or HDBase‑T output device to the DTP output (
Set the DTP/HDBT switch (
series, or HDBT for an HDBaseT enabled receiver.
ATTENTION:
•
Position this switch BEFORE connecting the appropriate device to the TP
connector. Failure to comply can damage the endpoint.
•
Positionnez le sélecteur AVANT de connecter l'appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager le
point de connexion.
Connect Over TP RS‑232 and IR control. Connect a serial RS-232 signal, a
modulated IR signal, or both into this 3.5 mm, 5-pole captive screw connector (
bidirectional RS-232 and IR communication (see
on page 11).
on page 46).
Securing the HDMI Connector
on page 15, for detailed information).
) to DTP if the receiving device is in the Extron DTP
D
Over TP RS‑232 and IR Connector
DTP T SW4 HD 4K • Installation
Mounting the
on page 12).
figure
2,
on
B
).
E
) for
F
4 4
Advertisement
Table of Contents
