Table of Contents
Advertisement
X*
= Switch mode
0 = Manual
1 = Auto
X(
= Firmware version (to the second decimal place)
X1)
= Output HDCP mode
0 = (default) Encrypt as required by input.
Continuous trials for HDMI sinks
Attempt for 10
1 = Always encrypt
Continuous trials for HDMI sinks
Attempt for 10 seconds on DVI sinks, then fail
2 = Encrypt as required by input.
Continuous trials for HDMI and DVI sinks
3 = Always encrypt
Continuous trials for HDMI and DVI sinks
X1!
= TMDS output format
0 = Auto (default)
1 = DVI RGB 444
2 = HDMI RGB "Full"
3 = HDMI RGB "Limited"
4 = HDMI YUV 444 "Full"
5 = HDMI YUV 444 "Limited"
6 = HDMI YUV 422 "Full"
7 = HDMI YUV 422 "Limited"
X1@
= Verbose mode
0 = Clear/none
1 = Verbose mode (default)
2 = Tagged responses for queries
3 = Verbose mode and tagged responses for queries
X1#
= Video mute
0 = Video mute disabled
1 = Video mute enabled (TMDS)
2 = Video and sync mute
X1$
= DTP/HDBT switch position
0 = DTP mode (default)
1 = HDBT mode
X1%
= Contact/Tally action (see
0 = Open
1 = Closed
X1^
= Contact/Tally ports
1 ‑ 6
X1&
= Contact/Tally modes
0 = Default setting
1 = Advanced Mode
2 = 1-4 are mutually exclusive; 5 and 6 are mutually exclusive
3 = 1-4 are mutually exclusive; 5 is single switch; 6 is single switch
X1*
= Contact closure status
0 = Stays in current channel if re-selected (default)
1 = Select 0 channel if current channel is re-selected
X1(
= Tally pin mode on channel mute
0 = Always on (default)
1 = Off when muted
2 = Blink when muted
X2)
= 5V Output Hot-Plug Mode
0 = Auto (5V enabled when source with 5V present, otherwise Off)
1 = Always enabled (default)
NOTE: Unless otherwise indicated, commands are not case-sensitive.
DTP T SW4 HD 4K • Remote Communication and Control
seconds on DVI sinks, then fail
Contact/Tally Modes
on page 15)
42
Advertisement
Table of Contents
