Table of Contents
Advertisement
Operation
This section describes the operation of the DTP T SW4 HD 4K switcher. Topics include:
•
•
•
•
•
Front Panel Features
AUTO
SWITCH
CONFIG
A A
B B
Auto Switch LED
A
Config port
B
Input selection buttons and LEDs
C
Figure 7.
A
B
C
Front Panel Features
Operations
Contact/Tally Modes
EDID Minder
HDCP
INPUTS
1
2
C C
DTP T SW4 HD 4K Front Panel
Auto Switch LED — This LED lights when auto-input switching is enabled (see
Auto‑Input Switching
on the previous page to set up automatic input selection).
Config port — Connect a USB cable (USB A to mini-B) between your computer and
this female USB mini-B port to configure and control the switcher via SIS commands or
PCS and to update the firmware (see
Input selection buttons and LEDs — Press one of these buttons to select an
input to switch to the output. The LED at the right of each button lights when the
corresponding input is selected. If auto-input switching is in effect, these buttons are
disabled, but the LEDs continue to light to indicate the selected input.
The input buttons are also used to:
Initiate a system reset (see
•
Enable and disable front panel lockout (see
•
Mode)
on page 24).
3
4
SIGNAL
1
HDCP
Inputs and Output Signal LEDs
D
HDCP status LEDs
E
Connecting to the USB Port
Resetting
on page 24).
Front Panel Lock (Executive
DTP T SW4 HD 4K • Operation
D D
INPUTS
OUTPUT
2
3
4
DTP T SW4 HD 4K
DTP HDMI SWITCHER
E E
on page 24).
13
Advertisement
Table of Contents
