Table of Contents
Advertisement
4.
On the next screen, select the
radio button (see figure 11,
(Recommended)
5.
Click
(
). You do not need to insert a disc.
Next
2
1
Figure 16.
Select the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the DTP T SW4 HD 4K
via the USB port and loads it to the computer hard drive.
6.
Click
to close the wizard when the
Finish
NOTE: This wizard appears only the first time you connect the DTP T SW4 HD 4K
to each USB port. You do not see the wizard again unless you connect the
switcher to a different USB port on your computer.
7.
Configure the switcher as desired using SIS commands (see the
Communication and Control
Software (see the
Product Configuration Software
Install the software automatically
below).
1
2
screen appears.
Completed
starting on page 40) or Product Configuration
starting on page 29).
DTP T SW4 HD 4K • Operation
Remote
26
Advertisement
Table of Contents
