Avaya 8600 Technical Configuration Manual page 27

avaya.com
Site1:5(config)# mlt 1 enable name "Site3"
Site1:5(config)# mlt 1 member 2/1
Site1:5(config)# mlt 1 encapsulation dot1q
Site1:5(config)# interface mlt 1
Site1:5(config-if)# smlt 1
Site1:5(config-if)# exit
Site1:5(config)# mlt 2 enable name "Site4"
Site1:5(config)# mlt 2 member 3/1
Site1:5(config)# mlt 2 encapsulation dot1q
Site1:5(config)# interface mlt 2
Site1:5(config-if)# smlt 2
Site1:5(config-if)# exit
Site1:5(config)# mlt 3 enable name "Site5"
Site1:5(config)# mlt 3 member 3/2
Site1:5(config)# mlt 3 encapsulation dot1q
Site1:5(config)# interface mlt 3
Site1:5(config-if)# smlt 3
Site1:5(config-if)# exit

Spanning Tree Protocol (STP) is automatically disabled on SMLT interfaces
2.2.3.3 MLT Configuration on SMLT edge devices
All of Sites 3, 4 and 5 (only Site3 shown)
CLI
Site3:5# config mlt 1 create
Site3:5# config mlt 1 add ports 2/1-2/2
Site3:5# config mlt 1 name "Site1-2"
Site3:5# config mlt 1 perform-tagging enable
Site3:5# config ethernet 2/1-2/2 stg 1 stp disable
ACLI
Site3:5(config)# mlt 1 enable name "Site1-2"
Site3:5(config)# mlt 1 member 2/1-2/2
Site3:5(config)# mlt 1 encapsulation dot1q
Site3:5(config)# interface GigabitEthernet 2/1-2/2
Site3:5(config-if)# no spanning-tree stp 1 enable
Site3:5(config-if)# exit
Network Design Implementation to Provide L2 & L3 VPN Connectivity
27
November 2010
between Sites using SMLT and IPVPN-Lite for ERS 8600
Technical Configuration Guide