Configure Ip Address - Planet SGSW-24040R User Manual
24-port 10/100/1000mbps layer 2 managed switch
Hide thumbs
Also See for SGSW-24040R:
- User manual (570 pages) ,
- Quick installation manual (12 pages) ,
- User manual (567 pages)
Table of Contents
Advertisement
1.
For security reason, please change and memorize the new password after this first setup.
2.
Only accept command in lowercase letter under console interface.
Configure IP address
The WGSW / SGSW Managed Switch is shipped with default IP address as following.
IP Address : 192.168.0.100
Subnet Mask : 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please use the procedures as follow:
Show the current IP address
1.
On "Switch/> " prompt, enter "show ip".
2.
The screen displays the current IP address, Subnet Mask and Gateway. As show in
Configure IP address
3.
On "Switch/> " prompt, enter the following command and press <Enter>. As show in
Figure 5-2 Show IP information screen
209
User's Manual of WGSW-24040 / WGSW-24040R
SGSW-24040 / SGSW-24040R
Figure
Figure
5-2.
5-3.
Advertisement
Table of Contents
